Saleofcar.com :Replica/Kit

Replica/Kit Makes (1967)
for sale

Price: US $38,500.00

Description:

Up for sale is an Everett Morrison built 1967 Shelby Cobra replica with 5649 miles. It was built in 1996 and all of the finest components were used. It is built using a 4” custom bent round tube frame. It has front rack and pinion steering, a Ford 9” positraction rear end w/ a 3.55 gear..
It has a 4-bar link suspension with a pan hard bar. It has aluminum adjustable coil covers at all four corners. The brakes are 11” Ford manual discs. It has a Tilton Racing master cylinder for the brakes and clutch.
The engine is a big-block Chevy 502 cubic inch mated to a Richmond 5-speed manual transmission. It is fuel injected with a manifold similar to a dual quad tunnel ram. It has a 1000cfm throttle body and is equipped with Taylor race wires, MSD ignition. This combination is good for horsepower north of 550. To round it out is a large capacity oil pan.
The exhaust is chrome side pipes with stainless heat shields.
The car has brand new seats with headrests that have been done in 2-tone red and tan leather. The interior is tan on the carpet and dash. The gauges are by VDO. The sound system consists of a Pioneer head unit with an alpine amplifier and 2 x 6x9 Polk Audio 2-way speakers and a Polk Audio subwoofer.
The steering wheel is a Moto-Lita and it has a Ford tilt column. The seatbelts are RJS racing lap and shoulder belts. It is Escort Radar Detector ready.
In terms of safety features, there is a chrome fire extinguisher, single roll bar and chrome nudge bars. The tires are also brand new - BF Goodrich Drag Radial T/A – with less than 100 miles on them.
The two known issues are an inoperative gas gauge and 2 small nicks in the windshield.
Other than that, the vehicle is road ready and ready to be driven anywhere. Also included is a car cover. The vehicle is sold as is.
Since this vehicle is also being sold locally, I reserve the right to pull this listing at any time.

_{update: 2015-07-22}